Lead acid battery pulse charging kit4/24/2023 ![]() Most pulse chargers use an external power source (wall AC) to power the device. “Having said that, I have tested some very complex and very expensive pulse chargers that appeared to recover sulfated batteries more quickly than traditional methods. “The problem is that if not done properly, it can do more damage than good,” says Wehmeyer. These techniques include DC (direct current) pulses using various voltages and currents, as well as AC (alternating current) pulses with a wide range of AC frequencies. Wehmeyer warns, however, that there are an infinite variety of pulse charging techniques used by a wide variety of equipment sold for this purpose. If your battery is sulfated, which results in low power and difficulty in recharging to full capacity, it can sometimes be recovered using proper pulse charging techniques. This may show a small, temporary increase in capacity but will quickly kill the battery. Acetic acid attacks the positive lead dioxide plates in the battery and permanently damages them, leading to short battery life. Wehmeyer says aspirin is acetylsalicylic acid, which eventually breaks down into acetic acid. This will also permanently reduce the capacity of the battery, which was most likely already low.Īdding aspirin to the battery is another hack that is often seen in videos claiming to revive dead batteries. Wehmeyer says that pouring baking soda into the battery cells will neutralize the sulfuric acid in the electrolyte to sodium sulfate that cannot discharge to lead sulfate in the normal discharge reaction. Baking soda mixed with water is often used to clean the tops of batteries and battery terminals because it neutralizes the sulfuric acid and acidic corrosion products. Other popular hacks include adding baking soda to recover a dead battery. Doing this will probably kill a potentially recoverable battery (see below). The specific gravity will be higher, but the battery plates are still discharged and/or sulfated. “If you filled a new lead battery with a magnesium sulfate solution instead of sulfuric acid electrolyte, it would have no capacity at all.” Simply put, adding Epsom salt will not recover the battery capacity but does “artificially” increase the SG.Īccording to Wehmeyer, the result would be similar if you remove the dilute electrolyte from a discharged and/or sulfated battery and refill it with the electrolyte for a fully charged battery (usually 1.270). “This is because the sulfates in the Epsom salt are tied up as magnesium sulfate and are not available for discharge to lead sulfate as the sulfates in sulfuric acid are,” said Wehmeyer. According to Wehmeyer, adding Epsom salt (magnesium sulfate) to a lead-acid battery will ‘artificially’ increase the specific gravity reading (SG), but because it does not increase the sulfuric acid concentration, it does nothing to improve battery performance. ![]() One of the more common ones is adding Epsom salt to the battery cells. He says that many of these hacks claim to show some type of improvement, but the gains shown may simply be artificial. ![]() Battery, has more than 50 years of experience in rechargeable battery design and development. It is also important to understand that many of the supposed “cures” can damage the battery, while others can be dangerous and do nothing to improve battery performance.įred Wehmeyer, Senior VP of Engineering at U.S. The truth is, there are many factors that contribute to poor battery performance and failure, and it is important to diagnose the symptoms of poor battery performance before determining a cure. Numerous online videos show a variety of ways to revive a dead or dying battery using various substances and hacks. When your deep-cycle battery nears end-of-life, it’s normal to want to squeeze as much out of it as possible before spending money on a new one.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |